Thingmagic Mercury xPRESS Platform v1.7 Manual de usuario Pagina 90

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 144
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 89
A DIVISION OF TRIMBLE
90 Using the Developer Toolkit
product_info.php?products_id=4650.
The Schematic can be found here:
http://microcontrollershop.com/download/ARM-JTAG_20-10-schematic.pdf and ARM-JTAG_20-
10-schematic.pdf
JTAG Hardware Installation
1. Unplug power from both the SAM-ICE (or other J-Link-based device) and the target
board. While not strictly necessary, it is safest to connect the two while powered
down.
2. Connect the SAM-ICE to the target board with a JTAG cable. Make sure the
connector and cable are oriented as shown below.
3. Plug the SAM-ICE into a USB port on the debug host computer.
4. Power up the target board. (This is most easily done by moving the Always-on jumper
to the “On” position - See the Quick Start Guide.)
5. Activate USB
Ensure that the USB port to the J-Link is active
Linux JLINK Software Installation (JLinkGDBServer)
The following instructions are for installation on a LINUX system. Skip to the next section
if you are using a Windows-based system.
Vista de pagina 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 143 144

Comentarios a estos manuales

Sin comentarios