Thingmagic Mercury xPRESS Platform v1.7 Manual de usuario Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 144
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
xPRESS Platform Contents
A DIVISION OF TRIMBLE
18 Quick Start Guide
xPRESS Platform Contents
The xPRESS development platform is shipped as an open system allowing maximum
flexibility in changing hardware configuration and peripherals. This chapter explains how
to assemble the development platform and operate the RFID Sensor demo program over
the USB interface. Once successful, you may want to run this application over one of the
optional module interfaces and add GPS location sensing. If so, consult the
Using the
Optional Modules section. Use caution when configuring the hardware.
Note
Always turn off the power and unplug the power cord before changing
hardware configuration and peripherals.
Hardware
Processor Motherboard with one module (either M6e, Micro, or Micro-LTE)
AC Power Adapter with international adapter plugs
Two USB cables
Antenna cable which converts MMCX to Reverse-TNC
The xPRESS Development Platform comes with an AC power adapter, two USB cables,
one antenna cable, and one of the UHF RFID modules shown in the picture. The red
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 143 144

Comentarios a estos manuales

Sin comentarios