Thingmagic Vega Manual de usuario

875-0030-03 RevAVega Reader Setup Guide

Reading Tags10 ThingMagic Vega Set Up GuideReading TagsThe following procedure explains how to install and activate the Reader Assistant on your PC. S

Using GPIO and ReaderEnableThingMagic Vega Set Up Guide 11Using GPIO and ReaderEnableTwo general purpose inputs, one general purpose output and the Re

Using GPIO and ReaderEnable12 ThingMagic Vega Set Up GuideNote: Note that there is no GPO-1 connection. This signal is used for switching between ant

MechanicalThingMagic Vega Set Up Guide 13MechanicalThe reader mounting is as shown in Vega Mechanical (all dimensions in cm). The four mounting holes

Mechanical14 ThingMagic Vega Set Up Guide2. Drill holes for the screws and install wall or ceiling anchors if required. For ceiling mount, use only

Vega Specifications 15 Vega SpecificationsPowerAC/DC Power RequiredReader : 10-16 VDC, 8 W maximum at 12 V when transmittingOptional AC Power Adapter

16 Vega SpecificationsAutomotive Environmental StandardsConfirmed to meet in-vehicle standards for:Powered Thermal Cycle (IEC 68-2-14wNb)Thermal Shock

Vega Specifications 17Performance Tag Read RateUp to 190 tags/second Tag Read Distance Over 30 feet (9 m) with 6 dBi antenna (36 dBm EIRP) Tag / Trans

18 Vega SpecificationsData/Control InterfaceData/Control 9-pin serial connector, supporting RS232 with asynchronous data rates up to 921.6 kbps. DTR s

Compliance Information 19 Compliance InformationFCC COMPLIANCEFCC ID: QV5SR5EThis equipment complies with Part 15 of the FCC rules for intentional ra

Government Limited Rights Notice: All documentation and manualswere developed at private expense and no part of it was developed usingGovernment funds

20 Compliance Information

3 ContentsThingMagic Vega Set Up Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

4Automotive Environmental Standards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16Electrostati

ThingMagic Vega Set Up Guide 5 ThingMagic Vega Set Up Guide

Introduction6 ThingMagic Vega Set Up GuideIntroductionThe Vega Reader kit is a self-contained reader that can be deployed as a UHF RFID reader with a

Included ComponentsThingMagic Vega Set Up Guide 7Included ComponentsWith the Vega RS, you will receive the following components: The ThingMagic Vega

Setting up Vega8 ThingMagic Vega Set Up GuideSetting up VegaWhen setting up Vega, use the following procedures:1. Connecting the Antenna(s)2. Po

Setting up VegaThingMagic Vega Set Up Guide 9NoteIn order to use the Antenna 2 port it is necessary to set the antenna configuration and toggle the GP