Thingmagic M6e Manual de usuario descargar pdf (Pagina 74)

Protocol Faults

74 Appendix A: Error Messages

FAULT_NO_TAGS_FOUND – (400h)

Cause

A command was received (such as like read, write, or lock) but the operation failed. There

are many reasons that can cause this error to occur.

Here is a list of possible reasons that could be causing this error:

No tag in the RF field

Read/write power too low

Antenna not connected

Tag is weak or dead

Solution

Make sure there is a good tag in the field and all parameters are set up correctly. The best

way to check this is to try few tags of the same type to rule out a weak tag. If none

passed, then it could be SW configuration such as protocol value, antenna, and so forth,

or a placement configuration like a tag location.

FAULT_NO_PROTOCOL_DEFINED – 401h

Cause

A command was received to perform a protocol command but no protocol was initially set.

The reader powers up with no protocols set.

Solution

A protocol must be set before the reader can begin RF operations.

FAULT_INVALID_PROTOCOL_SPECIFIED – 402h

Cause

The protocol value was set to a protocol that is not supported with the current version of

SW.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 99 100

Sin comentarios

Thingmagic M6e Manual de usuario Pagina 74