Thingmagic M6e Manual de usuario Pagina 60

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 59
Power Management
A DIVISION OF TRIMBLE
60 Functionality of the Mercury6e
Power Management
The M6e is designed for power efficiency and offers several different power management
modes. The following power management modes affect the power consumption during
different periods of M6e usage and impact performance in different ways. The available
power management modes are:
Power Modes - set in /reader/powerMode - Controls the power savings when the
M6e is idle.
Transmit Modes - set in /reader/radio/enablePowerSave - controls power
savings while transmitting.
Power Modes
The Power Mode setting (set in /reader/powerMode) allows the user to trade off
increased RF operation startup time for additional power savings. The details of the
amount of power consumed in each mode is shown in the table under Power
Consumption. The behavior of each mode and impact on RF command latency is as
follows:
PowerMode.FULL – In this mode, the unit operates at full power to attain the best
performance possible. This mode is only intended for use in cases where power
consumption is not an issue. This is the default Power Mode at startup.
PowerMode.MINSAVE – This mode may add up to 50 ms of delay from idle to RF on
when initiating an RF operation. It performs more aggressive power savings, such as
automatically shutting down the analog section between commands, and then
restarting it whenever a tag command is issued.
PowerMode.SLEEP – This mode essentially shuts down the digital and analog
boards, except to power the bare minimum logic required to wake the processor.This
mode may add up to 100 ms of delay from idle to RF on when initiating an RF
operation. PowerMode.SLEEP is not supported when using the USB interface.
Using the setting PowerMode.MEDSAVE is the same as SLEEP.
Note
See additional latency specifications under Event Response Times.
Transmit Modes
The Transmit Mode setting (set in /reader/radio/enablePowerSave) allows the
user to trade off RF spectral compliance with the Gen2 DRM Mask for increased power
savings while transmitting. The details of the amount of power consumed in each mode is
Vista de pagina 59
1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 99 100

Comentarios a estos manuales

Sin comentarios