Thingmagic Astra Manual de usuario descargar pdf (Pagina 27)

Networking the Reader

Astra User Guide 27

Using Power Over Ethernet (PoE)

Another way of powering up the Astra Reader is to use a single Ethernet cable that is

connected to a Power over Ethernet (PoE) network. In this configuration, the power

converter that is supplied with the Astra Reader is not used.

To power up the Astra Reader over a PoE network:

1. Connect one end of the Ethernet cable to the Astra Reader

2. Connect the other end to a certified PoE port.

ThingMagic recommends using a PowerDsine 3006 or similar PoE Hub.

Note

You must use the Ferrite Bead included with the Astra Reader when powering-up

the Reader over a PoE network. For proper operation, you must install the Ferrite

Bead on the Ethernet cable at the end closest to the Astra Reader, as shown in

Figure 10. For proper installation, the Ferrite Bead should not be more than two

inches away from the connector

Figure 10: Ferrite Bead

WARNING!

When using PoE as a power source, the PoE must be supplied by a UL Listed

ITE device.

WARNING!

When using PoE as a power source the unit cannot be connected to an Ethernet

network with outside plant routing, including a campus environment. The

network must be contained within a single building.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 74 75

Sin comentarios

Thingmagic Astra Manual de usuario Pagina 27